Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Materiale: Alluminio 7075 Rivestimento: Nero opaco Hardcoat Lunghezza totale: 1.780" Larghezza totale: 1.1" Hardware di montaggio: (2) Viti a testa piatta 6-32, (1) Vite di bloccaggio 6-32 X 3/16 Compatibilità del punto rosso: Trijicon RMR, Holosun HS507C Questo montaggio non è compatibile con: Rock Island 1911s Rimuovi semplicemente la mira posteriore della tua pistola e sostituiscila con il nostro montaggio per installare il tuo mirino red dot Trijicon RMR. Non sono necessarie modifiche. Puoi rimuovere il nostro montaggio e sostituire la mira posteriore in qualsiasi momento. Hardware di montaggio incluso. Istruzioni per l'installazione Rimuovi la mira posteriore* Installa il montaggio per mira EGW nella slitta Serrando la vite di bloccaggio (se applicabile) Posiziona il mirino red dot sul montaggio per mira EGW (posizionare un piccolo pezzo di carta tra il mirino red dot e il montaggio per mira faciliterà la rimozione e impedirà al Loctite di entrare in contatto con il mirino red dot.) Applica Loctite blu alle viti di montaggio fornite Serrare le viti di montaggio a 15in/lbs 2 Viti a testa piatta - Fornite per Trijicon RMR Le viti incluse con questo montaggio richiedono una chiave a brugola da 5/64'' per l'installazione.