The Sinclair Bullet Seating Depth Tool has been used for decades by handloaders seeking the most accuracy out of their rifles. Our newest model is made from one fourth inch ground and polished stainless steel with one end turned down for use with 17 and 20 caliber rifles and the other end used for 22 caliber and up. This tool helps you determine the length of a loaded round touching the rifling. The Sinclair Seating Depth Tool will work with most bolt action, single shot and AR type rifles. The tool includes a Delrin action guide suitable for most bolt-action rifles (0.690” Diameter fits Remingtons, Savages, Winchesters, and many Rugers). For the most accurate measurement, the Sinclair Bullet Seating Depth Tool uses your fireformed brass and bullets so you can expect an exact measurement, every time. Also available are guides use in AR-15's, AR-10's, and Tubb's 2000's. The guide is a little different than our standard bolt-action guides. This guide inserts into the back of the upper receiver (with the bolt removed). The tool is then used as normal. For best results couple this tool with our Bullet Comparators and a good set of calipers to get repeatable and precise Base-To-Ogive measurements.
Il Sinclair Bullet Seating Depth Tool è stato utilizzato per decenni dai ricaricatori che cercano la massima precisione dai loro fucili. Il nostro ultimo modello è realizzato in acciaio inossidabile lucidato e rettificato di un quarto di pollice, con un'estremità ridotta per l'uso con fucili di calibro 17 e 20, e l'altra estremità utilizzata per i fucili di calibro 22 e superiori. Questo strumento ti aiuta a determinare la lunghezza di un colpo caricato che tocca le righe della canna. Il Sinclair Seating Depth Tool funziona con la maggior parte dei fucili a otturatore, a colpo singolo e di tipo AR. Lo strumento include una guida per l'azione in Delrin adatta per la maggior parte dei fucili a otturatore (0.690” di diametro si adatta a Remington, Savage, Winchester e molti Ruger). Per la misurazione più accurata, il Sinclair Bullet Seating Depth Tool utilizza la tua cartuccia di ottone formata dal fuoco e proiettili, quindi puoi aspettarti una misurazione esatta, ogni volta. Sono disponibili anche guide per AR-15, AR-10 e Tubb's 2000. La guida è leggermente diversa dalle nostre guide standard per fucili a otturatore. Questa guida si inserisce nella parte posteriore del ricevitore superiore (con l'otturatore rimosso). Lo strumento viene quindi utilizzato normalmente. Per ottenere i migliori risultati, abbina questo strumento con i nostri Bullet Comparators e un buon set di calibri per ottenere misurazioni Base-To-Ogive ripetibili e precise.