Il Carrello è vuoto.

Carrello

Aiuto e contatti

Reso facile

Newsletter

Offerte

Oltre 300.000 clienti - vi ringraziamo!

4,93/5 "Molto buono" (1400+ recensioni)

Oltre 40.000 prodotti per caccia e sport di tiro

552 LENS COVER MODULE

813157001062 336000007

Protects The Lenses From Weather & Damage; Flips Open Instantly

Flexible rubber body with spring-loaded, ABS plastic covers help seal out dirt, dust and moisture to keep the lens surfaces of your EOTech holographic sight clean, scratch-free, and ready for use in all shooting conditions. Tabs on the right and left sides of the covers allow a fast, ambidextrous flip-open action with thumb or finger pressure. Front cover opens to near horizontal position to help block rain or sunlight. Rear cover folds back on top of the EOTech’s protective hood to ensure an unobstructed view through the sight. Body section installs under the EOTech protective hood, so it’s not even visible. Noise-absorbing neoprene pads dampen the sound of the rear lens cover contacting the hood during covert operations.

SPECS: Rubber body, ABS plastic covers, neoprene pads, matte black. 1 oz. (28.4g) weight. Includes Torx wrenches for installation. 511/512/551/552 - 23⁄8" (5.9cm) long, 17⁄8" (4.8cm) wide, 17⁄16" (3.6cm) high. Fits EOTech models 511, 512, 551, and 552.

Altro...

Protegge le Lenti dagli Agenti Atmosferici e dai Danni; Si Apre Istantaneamente

Corpo flessibile in gomma con coperchi a molla in plastica ABS che aiutano a sigillare lo sporco, la polvere e l'umidità per mantenere le lenti del mirino olografico EOTech pulite, prive di graffi e pronte all'uso in tutte le condizioni di tiro. Le linguette sui lati destro e sinistro dei coperchi consentono un'apertura rapida e ambidestra con la pressione del pollice o di un dito. Il coperchio anteriore si apre in posizione quasi orizzontale per aiutare a bloccare la pioggia o la luce solare. Il coperchio posteriore si ripiega sopra il cappuccio protettivo dell'EOTech per garantire una vista ininterrotta attraverso il mirino. La sezione del corpo si installa sotto il cappuccio protettivo dell'EOTech, quindi non è nemmeno visibile. I cuscinetti in neoprene assorbenti il rumore attutiscono il suono del contatto del coperchio della lente posteriore con il cappuccio durante le operazioni segrete.

SPECIFICHE: Corpo in gomma, coperchi in plastica ABS, cuscinetti in neoprene, nero opaco. Peso 1 oz. (28,4g). Include chiavi Torx per l'installazione. 511/512/551/552 - lunghezza 23⁄8" (5.9cm), larghezza 17⁄8" (4.8cm), altezza 17⁄16" (3.6cm). Compatibile con i modelli EOTech 511, 512, 551 e 552.

Altro...

Punteggi dei clienti per GG&G 511, 512, 551, 552 LENS COVERS

Numero di punteggi: 11
Da brownells.com: 11
Punteggio medio: 3,9

Great Product, A Must Have For Eotech (19/08/2009)

I am a police officer & have an EoTech mounted on my M4 Carbine. This cover protects the lenses of my Eotech & easy to install.
If you have an EoTech You have to get one of these.
You have invested good money on your EoTech.....Buy one of these & protect Your Investment.

lens cover (15/10/2009)

This works pretty well to keep your lens clean.
takes some power to get in place. NOTE: read your Eotech papper work. removing the Hood voids the warranty.

poor fit (22/04/2010)

while this is well made it does not snap shut very well one side will be flush while the other is not. both back and front is this way. very difficult to put on. almost need "jaws of life". if it wasn't so hard to remove i would ask for a refund!!!!!not worth the $$

Good idea, very poor execution (19/05/2010)

This item probably started out well in concept, but the end product barely functions. The cover body is molded rubber, which is about 1/8" too small lengthwise, causing poor fit and extremely poor function. The idea would be fine if GG&G changed the mold to allow for shrinkage of the rubber during production, but as is, this item isn't worth more than $10. Buy at your own risk.

Plus and minus (31/10/2011)

I work in law enforcement and carry my m4 almost every day. The cover was easy to put on and does what it says. The covers pop open with just a slight bump which is highly annoying. I had to rig the covers so they would not pop open. I would go with a scope coat or another model of this by a different company.

Great cover for that expensive optic. (14/11/2011)

I'm an LEO and firearms instructor for my PD. I have two AR's and run EOTechs on both. These covers are extremely easy to install and do what they say they're supposed to do. The front and rear covers remain closed when you want them to be and open quickly enough when you need to use the EOTech. Never a problem and highly recommend this item !

Great product (29/12/2011)

This one is worth the money. I found it easy to put on, just follow the directions. Very tight fit and a great seal on the ends. Take your time when you remove the hood.The screws are not very deep and have a little threadlocker on them.

Works as Advertised (27/08/2012)

If you are going to spend the money on the optics, then it is wise to protect your investment. This cover does it all. Do read the instructions and this will make installation easier. I am completely satisfied with this product.

Great accessory for my Eotech 512 HWS (28/02/2014)

I thought I would have a hard time installing this accessory on my Eotech 512 holographic weapons sight, but the installation went smooth and easy. I did not have to use any dish washing soap as was recommended in the instructions if the cover didn't fit on easy. Went on like a snap.
Be very careful removing the factory installed screws on the Eotech canopy. Best if you use a proper star tipped screwdriver rather than the Allen wrenches that come with the accessory as the factory installed screws have locktite on them.
The lens caps are a little difficult snapping open and closed, but still fits like a charm!
Also make sure that you put the rail piece back on the Eotech sight before putting the canopy back on the sight.
This accessory still deserves five stars!
I brought the model that says "Front Towards Enemy"

Mine required a little break in (26/01/2015)

When I first got my cover, it seemed to be very hard to get to snap shut, and the covers didn't want to open quickly. Now, around 6 months later everything feels like it was factory fit. Snaps shut solidly, and flips open completely and quickly. I actually use this on my shotgun which I use for almost every type of hunting, plus trap and sporting clays, so it got used quite a bit. I'm happy I stuck with it.

Price is the only down side (11/04/2015)

Works just fine on my 512. Easy to install, fit was perfect and no dishsoap was needed. I don't feel the price fit the product, a bit expensive for what you get. Doors open and close just fine with a secure snap. I'll purchase another since its the only sight protection of its kind.

Leggi più recensioni su brownells.com

89.9 89.9 1 EUR

N. prodotto: 336000007
GG&G 511, 512, 551, 552 LENS COVERS
Parti Fabbricante: GGG-1275 813157001062 Corpo flessibile in gomma con coperchi a molla in plastica ABS che aiutano a sigillare lo sporco, la polvere e l'umidità per mantenere le lenti del mirino olografico EOTech pulite, prive di graffi e pronte all'uso in tutte le condizioni di tiro. Le linguette sui lati destro e sinistro dei coperchi consentono un'apertura rapida e ambidestra con la pressione del pollice o di un dito. Il coperchio anteriore si apre in posizione quasi orizzontale per aiutare a bloccare la pioggia o la luce solare. Il coperchio posteriore si ripiega sopra il cappuccio protettivo dell'EOTech per garantire una vista ininterrotta attraverso il mirino. La sezione del corpo si installa sotto il cappuccio protettivo dell'EOTech, quindi non è nemmeno visibile. I cuscinetti in neoprene assorbenti il rumore attutiscono il suono del contatto del coperchio della lente posteriore con il cappuccio durante le operazioni segrete.

89.9 EUR 2 89,90 € *

Tempi di consegna circa 12-16 giorni.
2 pz. nel magazzino USA

Aggiungi alla lista degli acquisti

Domande

Dettagli

Aggiungi alla lista degli acquisti

Domande

Top takeaways

Copertura in gomma flessibile con coperchi a molla in plastica ABS per proteggere le lenti del mirino EOTech da sporco, polvere e umidità.
Apertura rapida e ambidestra con linguette sui lati; il coperchio anteriore blocca pioggia e luce solare, mentre quello posteriore garantisce una vista ininterrotta.
Include cuscinetti in neoprene per ridurre il rumore e chiavi Torx per l'installazione; compatibile con i modelli EOTech 511, 512, 551 e 552.

Caratteristiche

Peso della spedizione: 0,068kg Altezza di spedizione: 43mm Larghezza di spedizione: 124mm Lunghezza di spedizione: 157mm UPC : 813157001062

Dettagli dell'elemento

Made in Usa

Operatore economico responsabile secondo il regolamento UE

Brownells
Via Mezzavilla 4
25043 Breno
Italia
service@brownells.it

Proteggi le lenti del tuo EOTech con il modulo copertura GG&G. 💧 Facile apertura e design robusto per condizioni di tiro estreme.

Protects The Lenses From Weather & Damage; Flips Open Instantly

Altro...

Protegge le Lenti dagli Agenti Atmosferici e dai Danni; Si Apre Istantaneamente

Altro...

Punteggi dei clienti per GG&G 511, 512, 551, 552 LENS COVERS

Numero di punteggi: 11
Da brownells.com: 11
Punteggio medio: 3,9

Great Product, A Must Have For Eotech (19/08/2009)

lens cover (15/10/2009)

This works pretty well to keep your lens clean.
takes some power to get in place. NOTE: read your Eotech papper work. removing the Hood voids the warranty.

poor fit (22/04/2010)