Lee Bullet Sizing Kits are the fastest and easiest way to size cast bullets. Standard 7-8x14" threads fit any single stage reloading press. Bullets are pushed through the sizing die nose first, so no special nose punches are needed. Gas checks are automatically seated and crimped in place. Sized bullets are captured in the special container. Complete for one size. Press and bullet lubricant are sold separately. Special note: Intended for use on single stage presses only. The push through Punch is used in place of a Shell Holder in the Ram. Lee does not make top punches for molds. With the use of this kit, a top punch is not necessary. To crimp gas checks with the lube and size kit, first lubricate the bullets with liquid alox, push a gas check on the base of the bullet and set the bullet on the punch. When the bullet is pushed through the sizing die, the bullet will be sized, and the gas check will be crimped on. For cast bullets, you want to select a sizing kit to be .001" larger than groove diameter.
I kit di dimensionamento per proiettili Lee sono il modo più veloce e semplice per dimensionare i proiettili in piombo. Le filettature standard 7-8x14" si adattano a qualsiasi pressa di ricarica a singolo stadio. I proiettili vengono spinti attraverso il dies di dimensionamento con la punta in avanti, quindi non sono necessari punzoni speciali. I gas checks vengono automaticamente montati e crimpati in posizione. I proiettili dimensionati vengono catturati nel contenitore speciale. Completo per una dimensione. La pressa e il lubrificante per proiettili sono venduti separatamente. Nota speciale: destinato esclusivamente all'uso su presse a singolo stadio. Il punzone a spinta viene utilizzato al posto di un supporto per cartucce nel Ram. Lee non produce punzoni superiori per stampi. Con l'uso di questo kit, un punzone superiore non è necessario. Per crimpere i gas checks con il kit di lubrificazione e dimensionamento, prima lubrificare i proiettili con alox liquido, spingere un gas check sulla base del proiettile e posizionare il proiettile sul punzone. Quando il proiettile viene spinto attraverso il dies di dimensionamento, il proiettile sarà dimensionato e il gas check sarà crimpato. Per i proiettili in piombo, è consigliabile selezionare un kit di dimensionamento che sia .001" più grande del diametro della scanalatura.