The WFT 2 is the next generation of WFT trimmers. The two main improvements are the ability to trim up to 45 caliber and interchange trim chambers. The WFT 2 has a half inch shaft and requires a half inch chuck to drive it. The feature most customers asked for was the ability to interchange trim chambers. Instead of press fitting the trim chambers, like the original WFT, the trim chambers on the WFT 2 are a slight slip fit in bearing with a groove cut for an O-ring which creates a press fit. Changing out trim chambers is accomplished by removing the cutter and pushing out the trim chamber with the knock-out dowel that is provided. Installing the trim chamber is accomplished by setting the trim chamber on a flat surface and steadily pushing the housing onto the trim chamber. Setting the cutter depth is easily adjusted by placing a “master case” in the trim chamber and sliding the cutter up to the case mouth and tightening down the set screws. Trimming is just as precise and clean as with our original trimmer. The trim chamber selection on the WFT 2 is by specific cartridge, but still trims by case family-just order the largest chamber in the family that you intend to trim. This unit and its inserts do not chamfer or deburr the case moouth of the cartridge case as it is trimmed. If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015
Il WFT 2 è la nuova generazione di trimmer WFT. I due principali miglioramenti sono la capacità di rifilare fino al calibro 45 e la possibilità di intercambiare le camere di rifilatura. Il WFT 2 ha un albero di mezzo pollice e richiede un mandrino di mezzo pollice per essere azionato. La caratteristica richiesta dalla maggior parte dei clienti era la possibilità di intercambiare le camere di rifilatura. Invece di essere pressate come nel WFT originale, le camere di rifilatura del WFT 2 hanno un adattamento leggermente scorrevole in cuscinetto con una scanalatura per un O-ring che crea un adattamento a pressione. Cambiare le camere di rifilatura avviene rimuovendo il cutter e spingendo fuori la camera di rifilatura con il perno di espulsione fornito. Installare la camera di rifilatura si ottiene posizionando la camera di rifilatura su una superficie piana e spingendo costantemente l'alloggiamento sulla camera di rifilatura. La regolazione della profondità del cutter è facilmente effettuabile posizionando un “master case” nella camera di rifilatura e scorrendo il cutter fino alla bocca del bossolo e serrando le viti di regolazione. Il rifilamento è preciso e pulito come con il nostro trimmer originale. La selezione della camera di rifilatura sul WFT 2 è per cartuccia specifica, ma rifila ancora per famiglia di bossoli: basta ordinare la camera più grande della famiglia che si intende rifilare. Questa unità e i suoi inserti non smussano né sbavano la bocca del bossolo della cartuccia mentre viene rifilato. Se non riesci a trovare la cartuccia di cui hai bisogno, ti preghiamo di contattare il nostro Dipartimento Ordini Speciali al 800-741-0015.